Ametek ReFlex Programming Manual Manuel d'utilisateur télécharger pdf (Page 40)

ReFlex Power™ Programming Manual Controller Module Remote Programming

36 M380056-03 Rev M

2.6.2 C

OMMUNICATION WITH THE

YSTEM

Click within the Net Test window (Figure 2-14) to begin control

communications by inputting SCPI commands per the proper syntax and

conventions described herein.

2.7

SCPI COMMAND OPERATION

The SCPI command sets provide programming, query, and status commands

that facilitate remote control of the ReFlex Power™ system.

The system supports the SCPI 1999.0 status reporting data structures. These

structures are comprised of status registers and status register enable mask

pairs. The following sections describe these pairs.

2.7.1 E

RROR

VENT

UEUE

The Error/Event Queue, defined by SCPI holds up to ten error events. Issue

the SYSTem:ERRor? query to read the queue in a First In/First Out (FIFO)

manner. The read operation removes the entry from the queue. Issue the

*CLS command to clear all entries from the queue.

The following SCPI-defined error codes are in the range of [-32768, 32767].

SCPI reserves the negative error codes and 0, while error codes greater than

0 are device-specific errors.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 133 134

Pas de commentaire

Ametek ReFlex Programming Manual Manuel d'utilisateur Page 40