Ametek ReFlex Programming Manual Manuel d'utilisateur Page 127

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 134
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 126
Fixed Power DC Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 123
6.
FIXED POWER DC REMOTE
PROGRAMMING
6.1
INTRODUCTION
This section covers the remote programming option for the ReFlex Power™
Fixed Power DC Module. This interface enables operation of the Fixed Power DC
from a computer via the Ethernet, allowing full remote programming control and
monitoring of the Fixed Power DC module.
6.2
FEATURES AND FUNCTIONS
F
EATURES
Fixed Plus 5, Minus 5, Plus 15 and Minus 15 Volt Supply
SCPI compliant command set
Fixed Voltage Output
Field-upgradeable firmware via Ethernet
Soft calibration
P
ROGRAMMABLE
F
UNCTIONS
Over/Undervoltage protection
Output enable/disable
Maskable fault interrupt
Full calibration
R
EADBACK
F
UNCTIONS
Status and Accumulated Status registers
Programming error codes
Fault codes
Manufacturer, power supply model, serial number, and firmware
version identification
Vue de la page 126

Commentaires sur ces manuels

Pas de commentaire