Ametek ReFlex Programming Manual Manuel d'utilisateur télécharger pdf (Page 102)

ReFlex Power™ Programming Manual AC Module Remote Programming

98 M380056-03 Rev L

Command Description

:STATe <bool>

Set the initial POR output state of the unit

:STATe?

Query the initial POR output state setting of the unit

:FREQuency <NRi>

Set the initial frequency of the unit

:FREQuency?

Query the initial frequency of the unit

:DEFault

Set the initial value to default

:MODule

:LASTCAL <Date>

Set the last calibration date

:LASTCAL?

Query the last calibration date

:NEXTCAL <Date>

Set the next calibration date

:NEXTCAL?

Query the next query calibration date.

If CAL:INIT:STATe is ‘1’, the module will automatically turn on as if an OUTP:STATe

1 command had been received. This will only occur during initial power up, *RST will

only restore the saved CAL:INIT values. The unit will not automatically turn on if

enabled, after a *RST.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 133 134

Pas de commentaire

Ametek ReFlex Programming Manual Manuel d'utilisateur Page 102