Ametek ReFlex Programming Manual Manuel d'utilisateur télécharger pdf (Page 23)

M380056-03 Rev M 19

CONTROLLER MODULE REMOTE

PROGRAMMING

2.1

INTRODUCTION

This section covers the set up and remote programming of the ReFlex

Power™ system Controller (RFPC). All SCPI commands for the ReFlex

Power™ system will pass through the RFPC, which validates the command

syntax and confirms that the target module(s) exist, before sending the

command through. While most commands are intended for specific modules

or module groups, some commands will affect the entire system, and others

will return information from the RFPC.

The syntax of all SCPI commands implemented by the ReFlex Power™

system and documented in this manual, are either SCPI confirmed in the

SCPI 1999.0 Specification, Volume 2: Command Reference, or they are

customized commands not part of the SCPI definition but conform to SCPI

syntax.

The design of the RFP System is based on a loosely coupled, multi-user,

multi-processor, pre-emptive multitasking, and multi-threaded control system,

composed of semi-autonomous modules. This allows multiple users to control

various parts of the RFP system independently from each other. User

coordination is required.

2.2

FEATURES AND FUNCTIONS

EATURES

• SCPI compliant command set

• Field-upgradeable firmware via Ethernet

• Support for 96 modules

EADBACK

UNCTIONS

• Status and Accumulated Status registers

• Programming error codes

• Fault codes

• Manufacturer, power supply model, serial number, and firmware

version identification

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 133 134

Pas de commentaire

Ametek ReFlex Programming Manual Manuel d'utilisateur Page 23