Ametek SFA Series Ethernet Programming Manuel d'utilisateur télécharger pdf (Page 91)

SG Series Programming SCPI Command Operation

M550129-03 Rev K

6-19

Command

Description

SCPI

:FOLD

<0|1|2>

Sets the foldback (program down) mode of the supply. Valid

arguments are 0 (OFF or do nothing, do not program down to zero),

1 (program down to zero upon entering constant-voltage mode), or

2 (program down to zero upon entering constant-current mode).

:FOLD?

Returns the set foldback (program down) mode of the supply.

0 = OFF; will not program down.

1 = will program down to zero upon entering constant-voltage

mode.

2 = will program down to zero upon entering constant current mode

:SENSe

Sets the sense relay signal open or close. Valid arguments are

1/ON or 0/OFF.

:SENSe?

Returns the setting of the sense relay signal:

1 = ON 0 = OFF

:STATe

Sets the output to zero or the programmed value; opens or closes

the isolation relay. Valid arguments are 1/ON or 0/OFF. *RST

state value is ON.

:STATe?

Returns the state of the output:

1 = ON 0 = OFF

:TRIPped?

Returns the integer value 1 (TRIPPED) or 0 (UNTRIPPED) state of

the output.

6.8

STATUS SCPI COMMAND SUBSYSTEM

This section first presents a tree summary of the STATus commands and

then provides a tabular description.

Note: See Section 5 for further information.

6.8.1

STATUS SCPI Command Summary

STATus

:OPERation

:CONDition?

:ENABle <NR1>

:ENABle?

:EVENt?

:PRESet

:PROTection

:CONDition?

:ENABle <NR1>

:ENABle?

:EVENt?

:SELEct <NR1>

:SELEct?

:QUEStionable

:CONDition?

:ENABle <NR1>

:ENABle?

:EVENt?

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 158 159

Commentaires sur ces manuels

Pas de commentaire

Ametek SFA Series Ethernet Programming Manuel d'utilisateur Page 91

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ametek SFA Series Ethernet Programming