Ametek SFA Series Ethernet Programming Manuel d'utilisateur télécharger pdf (Page 112)

SCPI Command Operation SG Series Programming

6-40 M550129-03 Rev K

Command

Descripti

SCPI

:NAME “sequence

name”

Performs one of two possible actions. Either selects an

already existing sequence for use. (See the

PROG:CAT? command for a list of saved sequences

that may be selected.) Or provides a name for a new

sequence. The action that is performed depends upon

the “sequence name” and whether is already exists in

sequence memory or not. A sequence name must not

be longer than 15 characters. After naming a new

sequence, the sequence is in the EMPTY state. The

next required action to the sequence is to use the

MALLocate command to allocate memory for the newly

named sequence. After the MALLocate command is

issued, the new sequence goes from the EMPTY state

to the EDIT state.

:NAME?

Returns the name of the presently selected sequence.

If no sequence is presently selected, such as occurs

after a *RST command, then the default sequence will

be TEST01.

:STATe <state

name>

Provides a means to change the state of a sequence.

The states that may be issued are as follows: RUN,

RESUME, PAUSE, STOP, and COMPLETE.

A table showing allowable state transitions:

requeste

present

RUN RESUM

PAUSE STOP COMPL

RUNNIN

*error* *error* PAUSE

STOPP

*error*

PAUSE

*error* RUNNIN

PAUSE

STOPP

*error*

STOPP

RUNNIN

*error* STOPP

STOPP

*error*

EDIT *error* *error* *error* *error* STOPP

EMPTY

*error*

ERROR

*error*

INITIALI

*error* *error* *error* *error* *error*

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 158 159

Commentaires sur ces manuels

Pas de commentaire

Ametek SFA Series Ethernet Programming Manuel d'utilisateur Page 112

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ametek SFA Series Ethernet Programming