Ametek SFA Series Ethernet Programming Manuel d'utilisateur télécharger pdf (Page 90)

SCPI Command Operation SG Series Programming

6-18 M550129-03 Rev K

6.7

OUTPUT SCPI COMMAND SUBSYSTEM

This section first presents a tree summary of the OUTPut commands and

then provides a tabular description.

6.7.1

OUTPUT SCPI Command Summary

OUTPut

:ISOLation <boolean>

:ISOLation?

:POLarity <string>

:POLarity?

:PROTection

:DELay <NRf>

:DELay?

:FOLD <0|1|2>

:FOLD?

:SENSe <boolean>

:SENSe?

:STATe <boolean>

:STATe?

:TRIPped?

6.7.2

OUTPUT SCPI Command Reference

The letter “C” in the “SCPI” column means that the command syntax is

SCPI compliant; an “N” in the “SCPI” column means that the command

syntax is not part of the SCPI definition.

Command

Description

SCPI

OUTPut

Output subsystem. C

:ISOLation

Sets the rear panel isolation relay control signal ON or OFF. Valid

arguments are 1/ON or 0/OFF.

:ISOLation?

Returns the state of the rear panel isolation relay control signal: 1 =

ON 0 = OFF

:POLarity

<NORM/0/OFF|INV/1/

ON>

Changes the state of the polarity relay. This command requires that

the isolation relay be open beforehand. If the isolation relay is

closed when this command is attempted, the state of the polarity

relay will not change, and an error message will be generated.

:POLarity?

Returns the state of the polarity relay:

:PROTection

Output Protection subsystem. N

:DELay <NRf>

Sets the programmable time delay executed by the supply before

reporting output protection conditions after a new output voltage or

current is specified. Functional granularity of +/- 0.5 seconds

:DELay?

Returns the time delay to be executed by the supply. N

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 158 159

Commentaires sur ces manuels

Pas de commentaire

Ametek SFA Series Ethernet Programming Manuel d'utilisateur Page 90

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ametek SFA Series Ethernet Programming