Ametek BPS Series Programming Manual Manuel d'utilisateur télécharger pdf (Page 55)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power

Manual P/N 7003-961 Rev. AA 55

4.5 Array Measurement Subsystem [3Pi Controller Only]

This command subsystem lets you retrieve arrays containing measurement data. Only

current and voltage measurements are stored in an array. Two measurement commands

are available: MEASure and FETCh. A MEASure command triggers the acquisition of new

data before returning the readings from the array. A FETCh command returns previously

acquired data from the array.

Individual outputs of a three-phase source are specified by the setting of

INSTrument:NSELect.

Subsystem Syntax

MEASure | FETCh

:ARRay

:CURRent

[:DC]? Returns the digitized instantaneous current

:HARMonic

[:AMPLitude]? Returns amplitudes of the first 50 harmonics

:PHASe? Returns phase angles of the first 50 harmonics

:MODE Selects waveform data transfer format

:VOLTage

[:DC]? Returns the digitized instantaneous voltage

:HARMonic

[:AMPLitude]? Returns amplitudes of the first 50 harmonics

:PHASe? Returns phase angles of the first 50 harmonics

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 225 226

Pas de commentaire

Ametek BPS Series Programming Manual Manuel d'utilisateur Page 55