Ametek BPS Series Programming Manual Manuel d'utilisateur télécharger pdf (Page 113)

BPS / MX / RS Series SCPI Programming Manual AMETEK Programmable Power

Manual P/N 7003-961 Rev. AA 113

4.23 Status Subsystem Commands

This subsystem programs the AC/DC power source status registers. There are four groups

of status registers;

• Operation Status Group

• Questionable Status Group

• Questionable Instrument Isummary Group

• Standard Event Group

The Standard Event group is programmed with Common commands. The Operation,

Questionable, and Instrument ISummary status groups each consist of the following three

registers:

Condition Enable Event

Refer to chapter 7 for more information about the status registers.

Subsystem Syntax

STATus

:OPERation

:EVENt Returns the value of the event register

:CONDition Returns the value of the condition register

:ENABle <n> Enables specific bits in the Event register

:QUEStionable

:EVENt Returns the value of the event register

:CONDition Returns the value of the condition register

:ENABle <n> Enables specific bits in the Event register

:INSTruments

:ISUMmary

:EVENt Returns the selected phase’s event register value

:CONDition Returns the selected phase’s condition register

:ENABle Enable specific bits in selected phase’s Event

Bit Configuration of Status Operation Registers

Bit Position 15-5 4 3 1-2 0

Bit Name not used MEAS TRANS not used CAL

Bit Weight 16 8 1

CAL Calibration is completed

TRANS Transient is completed

MEAS Measurement is completed

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 225 226

Pas de commentaire

Ametek BPS Series Programming Manual Manuel d'utilisateur Page 113