Ametek CW Series Programming Manual Manuel d'utilisateur télécharger pdf (Page 25)

Sample Programs Elgar CW-P Series

C-2 Programming Manual

8. Turn On RMS loop

SOUR:VOLT:RMSLOOP ON (1)

9. Turn Off RMS loop

SOUR:VOLT:RMSLOOP OFF (0)

10. Turn Off RMS loop

SOUR:VOLT:RANGE LO

SOUR:VOLT 120

OUTPUT ON The CW-P will source 120V to the output

terminals in low range. If you send the command:

If you send the command:

SOUR:VOLT:RANGE HI The output relay will open, the voltage will drop

to zero.

11. If the CW-P supply is sourcing to the output terminals (output relay closed,

voltage>0), and you send the command:

SYST:RECALL 31

(any number 0..99)

When the recalled parameters are in the same

range that the CW-P is presently operating in,

the output relay will remain closed, and the

voltage, phase, current limit, etc. will go to the

new values.

When the recalled parameters are in the

opposite range (LOW, HIGH) that the CW-P

is presently operating in, the output relay will

remain open, delay one second, and then re-

close. Then CW-P then will go to the new

recalled parameters.

1 2 ... 20 21 22 23 24 25

Pas de commentaire

Ametek CW Series Programming Manual Manuel d'utilisateur Page 25