Ametek CW Series Programming Manual Manuel d'utilisateur télécharger pdf (Page 24)

Programming Manual C-1

APPENDIX C

SAMPLE PROGRAMS

The following examples will illustrate how to perform certain functions on the CW-P

using SCPI via the GPIB interface or the RS-232 channel.

NOTE: See the CW-P Series Operation Manual for examples of how to use

Slave commands.

1. Source AC from power up

SOUR:VOLT:RANGE LOW Specify low range 0-156V 13 Amps

SOUR:CURR 3 Specify 3 Amps current limit; foldback mode

SOUR:VOLT 120 Specify 120 VAC setpoint

SOUR:FREQ 60 Specify 60 Hz frequency

OUTP ON Source power to the output

2. Turn off Front Panel Programmability

SYST:KLOCK ON (1) Lock the program keys out

3. Turn on Front Panel Programmability

SYST:KLOCK OFF (0) Front panel program keys now function

4. Provide Zero Crossing pulses from Phase A

SYST:EXT:CLOCK OUT

5. Phase Lock Loop clock input

SYST:EXT:CLOCK IN

6. Turn on External Analog Gain control

SYST:EXT:ANAIN ON (1)

7. Turn off External Analog Gain control

SYST:EXT:ANAIN OFF (0)

1 2 ... 19 20 21 22 23 24 25

Pas de commentaire

Ametek CW Series Programming Manual Manuel d'utilisateur Page 24