Ametek 7100 Leak Detect Stik Manuel d'utilisateur télécharger pdf (Page 6)

The type of information contained in each reading varies depending on the probe type. Table 2 species the data

pattern for various probe types.

Table 2 - Reading Data Type Specication by Probe Type

Types 1, 2, 3 Types 4, 5, 6

Reading 1 Temp 1 Temp 1

Reading 2 Product or Water* Product or Water*

Reading 3 Low Ref Temp Temp 2

Reading 4 Product Product

Reading 5 High Ref Temp Temp 3

Reading 6 Product Product

Reading 7 Low Ref Temp Temp 4

Reading 8 Product Product

Reading 9 High Ref Temp Temp 5

Reading 10 Product Product

Reading 11 Circuit Temp Circuit Temp

Reading 12 Product Product

Reading 13 Low Ref Temp Low Ref Temp

Reading 14 Product Product

Reading 15 High Ref Temp High Ref Temp

* For single oat probes, this frame contains product data.

For dual oat probes, this frame contains water data.

When calculating Water or Product positions, one must consider whether or not the probe uses a reference

magnet. For probes that use a reference magnet (type 3 and type 6), position can be calculated using the

following formula:

Position = Measured Period/Wire Speed

Where:

Measured Period = the time between pulses in a reading (ms)

Wire Speed = (ms / inch)

Position = distance from internal reference

For probes that do not use a reference magnet (types 1, 2, 4, and 5), position can be calculated using the

following formula:

Position = Measured Period/Wire Speed*2

1 2 3 4 5 6 7 8 9 10 11 ... 21 22

Pas de commentaire

Ametek 7100 Leak Detect Stik Manuel d'utilisateur Page 6