Ametek 1970 Drive Check Control Manuel d'utilisateur télécharger pdf (Page 3)

1. Align Drive Sprockets and mount DRIVE-CHEK

base using 5/16" bolts.

2. Engage proper length drive chain to allow hinge

plate to be parallel to the base when drive chain

is tight.

3. Attach flexible conduit to allow free movement of

the hinge plate.

4. Set switch adjustment bolt to engage indicator

switch if the drive chain breaks.

5. Tighten adjustment bolt locknut.

6. Assemble springs with washers on each end of

the coil springs and self-locking nuts. The springs

should be compressed to nearly solid height.

7. Check the movement of the hinge plate to insure

that the conduit and chain guard does not restrict

the hinge plate from tripping the DRIVE-CHEK

Indicator Switch.

MOUNTING and SET-UP for GEMCO DRIVE-CHEK

with DRIVE CHAIN UNIT

1 2

3 4

5 6

6A - Drive chain below is the same procedure to

install

1 2 3 4

Pas de commentaire

Ametek 1970 Drive Check Control Manuel d'utilisateur Page 3