Ametek DCS-E 1kW Series Programming Manual Manuel d'utilisateur télécharger pdf (Page 27)

DLM-E Series and DCS-E Series Isolated Analog Programmer Operation

2.3.9 Programming the Shutdown Function

+5V

GND

Figure 2–3. Using Shutdown with a DC Input (Positive Logic)

2.3.10 TTL Shutdown

Set up for Shutdown input signal as follows:

1. Connect the shutdown signal source to the ISOLATED ANALOG PROGRAMMER

connector, J4, with positive to Pin-14 and the return to Pin-2.

2. Set switch SW1-6 to select the desired logic as defined in the following table.

Switch SW1-6 Setting Signal Level Output Condition

Low OFF

OFF (0) = Negative Logic

High ON

High OFF

ON (1) = Positive Logic

Low ON

M51A Option 2-15

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Ametek DCS-E 1kW Series Programming Manual Manuel d'utilisateur Page 27