Ametek DCS-E 1kW Series Programming Manual Manuel d'utilisateur télécharger pdf (Page 26)

Isolated Analog Programmer Operation DLM-E Series and DCS-E Series

2.3.8 4-20mA Current Source Programming of Output Current

SW1 Switch Settings

SW1-2 ON (1) = 4-20mA

4-20mA

111213 12

1423

Set up for 4-20 mA programming of the output current as follows:

1. Set SW1-2, I PROG, to ON (1) for 4-20mA programming range.

2. Connect the external programming current source to the ISOLATED ANALOG

PROGRAMMER connector, J4, with the source to Pin-10 and the return to Pin-13.

3. Connect a jumper from Pin-13 to Pin-12 to connect the 4-20mA current sense resistors

to common.

4. Connect a jumper from Pin 23 to Pin 11 to provide the negative 2.5VDC to zero out the

4mA signal generated by internal circuits.

5. Connect Pin-1, ANALOG-CONTROL, of the ISOLATED ANALOG PROGRAMMER

connector, J4, to Pin-2 to enable remote control.

6. Program the other parameters to the desired limit values.

2-14 M51A Option

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Ametek DCS-E 1kW Series Programming Manual Manuel d'utilisateur Page 26