Ametek 1746 LDT Interface Card Manuel d'utilisateur télécharger pdf (Page 9)

Chapter 3: Set-Up & Programming

Installation & Programming Manual

Command 1: Configuration

The 1746R PLC Resolver Interface Module can be configured for 6 different applications:

 Single axis, single turn resolver with no turns counting and one brake monitor input.

 Multi-turn dual resolver with no inputs.

 Single axis, single turn resolver with turns counting and one reset-to-preset input.

 Two axis, two single turn resolvers with turns counting and two reset-to-preset inputs.

 Multi-turn dual resolver with one reset-to-preset input.

 Two axis, two single turn resolvers; one with no turns counting and one brake

monitor input; the other with turns counting and one reset-to-preset input.

NOTE: All reserved locations should be set to 0.

displayed in the input image table as:

35 ;high word

111 ;low word

Note: If using Configuration 6, the resolver 1 position is displayed only as one word. Therefore,

the new data format does not apply to this position.

With the new data format option selected, the position can range from 0 to 32767999.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Pas de commentaire

Ametek 1746 LDT Interface Card Manuel d'utilisateur Page 9