Ametek XHR 1000 Watt Series Manuel d'utilisateur télécharger pdf (Page 22)

Features and Specifications

Rear Panel Connectors and Switch

22 Operating Manual for XHR Series Power Supply

Wiring

For lowest noise performance, make connections to the J2 connector with either

individually or group shielded 18-22 AWG (0.3-0.8 mm

) wire. Maintain the shield

to within 1.5in. (40 mm) of the end of each wire. Strip 0.26.in (6.5 mm) of insulation,

insert into the correct terminal, and tighten the wire clamp. You must ground the

shield(s) to the power supply chassis with a connection less than 1.5.in (40 mm)

long.

WARNING

There is a potential shock hazard at the output and J2 terminals when using a

power supply with a rated output greater than 40 V. Use load wiring with a

minimum insulation rating equivalent to the maximum output voltage of the

power supply. For example, select TEW-105, 105 °C, 600 V wiring for use with a

600 V, 1.7 A model power supply

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 81 82

Pas de commentaire

Ametek XHR 1000 Watt Series Manuel d'utilisateur Page 22