Ametek 2120 PLC Interface Module Manuel d'utilisateur télécharger pdf (Page 46)

Installation and Programming Manual

Chapter 4: Programming

Analog output channel 2 is programmed using the same basic sequences except with the function

numbers noted below. Remember that the X shown in the function number represents the slot in

which the analog output board is installed in the Interface Module chassis.

Analog Output Channel 2 - Function numbers

A) Select analog output based on position or velocity

Function No. X07

B) Select voltage or current output

Function No. X10

C) Scaling analog output

- Select minimum position/velocity value

Function No. X08

- Select analog output value to be linked to minimum position/velocity value

Function No. X11

- Select maximum position/velocity value

Function No. X09

- Select analog output value to be linked to maximum position/velocity value

Function No. X12

Analog output channel 1 will now provide a 2 to 8 VDC output as RPM increases between 500

and 2000 RPM. RPM values below 500 RPM will result in a 2 VDC analog output. RPM values

above 2000 RPM will result in an 8 VDC output.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 63 64

Pas de commentaire

Ametek 2120 PLC Interface Module Manuel d'utilisateur Page 46